Information concerning the RPW software modes. A full description of the RPW DPU software and its modes can be found in RPW-SYS-SSS-00013-LES.
RPW Software Modes
Figure below gives the RPW mode transition diagram.
RPW Software Science Sub-Modes
Figure below gives the RPW submodes transition diagram.
Add sub-modes figure from SSS
SBM_DETECTION sub-mode
SBM1
Tip | ||
---|---|---|
| ||
If required, it is possible to dump by TC (TBD) into the SBM SSMM packet store the content of the SBM1 buffer. |
SBM2
Tip | ||
---|---|---|
| ||
The TC_TDS_DUMP_SBM2_TSWF is sent by the DPU every SY_DPU_TDS_SBM2_TSWF_PER seconds to TDS, in order to retrieve the TSWF data in SBM2 mode. The default value of SY_DPU_TDS_SBM2_TSWF_PER is 300 sec., but it can be set by sending a TC_DPU_LOAD_SBM2_PAR. Note that the TC_TDS_DUMP_SBM2_TSWF can also be sent from ground to force the DUMP (only for testing purpose). |