About the preparation and analysis of the RPW/SCM noise measurements, to be performed during spacecraft Earth magnetic lobes crossing.
General
Purpose & Objectives
During the CP (TBC), Solar Orbiter will pass inside the Earth magnetic lobes, where the B field amplitude is very low. It is the occasion for RPW to measure the SCM sensitivity.
The SCM Noise Measurement Working Group (SNMWG) is in charge to prepare the operation (timeline, RPW config and associated flight procedures, expected data volume and power, etc.) and participate to the data analysis.
Working Group Members
- Xavier Bonnin – ROC manager (LESIA)
- Milan Maksimovic – RPW PI (LESIA)
- Olga Alexandrova – RPW/SCM operations scientist (LESIA) – WG leader
- Diane Berard – RPW operations engineer (LESIA)
- Matthieu kretzschmar – SCM config, data analysis (LPC2E)
Operation preparation
Overall timeline
Give here the overall timeline of the operation, including the expected instrument operating configurations.
Orbitography
Give here the orbitography (i.e., time versus S/C orbit/attitude)
Operation Constraints
Give here the operation constraints at RPW and SOLO levels (e.g., TM rate, PW, SOOP, etc.)
Command/Control
Give here the list of flight procedures and IOR (PDOR?) required to execute this operation
Data analysis
Expected data products
Give here the list of expected data products
Results
Give here the results of the data analysis (can be attached file, or link to references)