Context
IGST 4_2 are tests run at MOC (ESA Darmstadt) on May 15th 2018, in order to test sequences of:
- Switch-on,
- Ping,
- exercise the different modes and changes between them (test the state model in the ORCD),
- dump with S6 of one of the instrument memories,
- Switch-off.
The datapack which contains the procedure, sequences and the timeline of the plan is given in RPW IGST page.
Tests have ben run by :
- S. Lodiot (MOC)
- D. Bérard (ROC)
- A. Vecchio (ROC)
Test environnement
IGST 4_2 tests have been run on MEB EM2 with IDB 4.3.3.
Sequences used during the tests were send to MOC weeks before and were available for IGST test.
A slot of two hours were dedicated to RPW tests, during which each sequence was send manually. Between two sequences, TM parameters were checked manually.
Results
Table below gives the timeline of the tests, and corresponding comments.
Category | Sequence number | Mode at first | Mot at end |
---|---|---|---|
Standart switch on procedure | AIWF011A | OFF | SAFE |
AIWF370A | Ping | ||
AIWF030A | SAFE | STANDBY | |
AIWF031A | STANDBY | SERVICE | |
Configuration | AIWF032A | configure HK period | |
AIWF032B | Load DPU and DAS common parameters | ||
AIWF032C | Load DPU and DAS power parameters | ||
AIWF032E | Configure parameters for monitoring temperature | ||
AIWF032F | Configure Waveform parameters | ||
AIWF032G | Configure SBM1 parameters | ||
AIWF032H | Configure SBM2 parameters | ||
AIWF032I | Configure SC potential computation algorithm | ||
AIWF032J | Clear HK counter | ||
AIWF032K | Enable HK parameter report generation | ||
AIWF037A | THR for Normal | ||
AIWF037B | THR for Burst | ||
AIWF037C | THR calibration parameters | ||
AIWF038A | TDS common param | ||
AIWF038E | TDS for Normal | ||
AIWF038B | TDS for SBM1 | ||
AIWF038C | TDS for SBM2 | ||
AIWF038D | TDS LFM | ||
AIWF038F | TDS for Burst | ||
AIWF039A | LFR for SBM1 | ||
AIWF039B | LFR for SBM2 | ||
AIWF039C | LFR common param | ||
AIWF039D | LFR for Normal | ||
AIWF039E | LFR for Burst | ||
AIFW034A | Dump TDS,LFR,THR parameters | ||
AIWF260A | Dump memory | ||
Test of any SCIENCE modes transitions | AIWF035A | SERVICE | SCIENCE NORMAL |
AIWF035B | SCIENCE NORMAL | SCIENCE BURST | |
AIWF035C | SCIENCE BURST | SBM DETECTION | |
AIWF043A | SBM DETECTION | SERVICE | |
AIWF035C | SERVICE | SBM DETECTION | |
AIWF035B | SBM DETECTION | SCIENCE BURST | |
AIWF035A | SCIENCE BURST | SCIENCE NORMAL | |
AIWF035C | SCIENCE NORMAL | SBM DETECTION | |
AIWF035A | SBM DETECTION | SCIENCE NORMAL | |
AIWF043A | SCIENCE NORMAL | SERVICE | |
AIWF044A | SERVICE | SCIENCE BACK UP | |
AIWF043A | SCIENCE BACK UP | SERVICE | |
Test of switching on each analyzers independently (IW-FCP-042) | AIWF045A | SERVICE | STANDBY |
AIWF043A | STANDBY | SERVICE | |
AIWF042A | Switch on the converter (CONV) | ||
AIWF042B | BOOT LFR | ||
AIWF042C | Boot THR | ||
AIWF042D | Boot TDS | ||
AIWF042E | Switch ON BIAS | ||
AIWF037A | THR for Normal | ||
AIWF037B | THR for Burst | ||
AIWF037C | THR calibration parameters | ||
AIWF038A | TDS common param | ||
AIWF038E | TDS for Normal | ||
AIWF038B | TDS for SBM1 | ||
AIWF038C | TDS for SBM2 | ||
AIWF038D | TDS LFM | ||
AIWF038F | TDS for Burst | ||
AIWF039A | LFR for SBM1 | ||
AIWF039B | LFR for SBM2 | ||
AIWF039C | LFR common param | ||
AIWF039D | LFR for Normal | ||
AIWF039E | LFR for Burst | ||
AIFW034A | Dump TDS,LFR,THR parameters | ||
AIWF035A | SERVICE | SCIENCE NORMAL | |
AIWF045A | SCIENCE NORMAL | STANDBY | |
AIWF031A | STANDBY | SERVICE | |
AIWF037A | THR for Normal | ||
AIWF037B | THR for Burst | ||
AIWF037C | THR calibration parameters | ||
AIWF038A | TDS common param | ||
AIWF038E | TDS for Normal | ||
AIWF038B | TDS for SBM1 | ||
AIWF038C | TDS for SBM2 | ||
AIWF038D | TDS LFM | ||
AIWF038F | TDS for Burst | ||
AIWF039A | LFR for SBM1 | ||
AIWF039B | LFR for SBM2 | ||
AIWF039C | LFR common param | ||
AIWF039D | LFR for Normal | ||
AIWF039E | LFR for Burst | ||
AIFW034A | Dump TDS,LFR,THR parameters | ||
AIWF044A | SERVICE | SCIENCE BACK UP | |
AIWF045A | SCIENCE BACK UP | STANDBY | |
AIWF031A | STANDBY | SERVICE | |
AIWF037A | THR for Normal | ||
AIWF037B | THR for Burst | ||
AIWF037C | THR calibration parameters | ||
AIWF038A | TDS common param | ||
AIWF038E | TDS for Normal | ||
AIWF038B | TDS for SBM1 | ||
AIWF038C | TDS for SBM2 | ||
AIWF038D | TDS LFM | ||
AIWF038F | TDS for Burst | ||
AIWF039A | LFR for SBM1 | ||
AIWF039B | LFR for SBM2 | ||
AIWF039C | LFR common param | ||
AIWF039D | LFR for Normal | ||
AIWF039E | LFR for Burst | ||
AIFW034A | Dump TDS,LFR,THR parameters | ||
AIWF035C | SERVICE | SBM DETECTION | |
AIWF045A | SBM DETECTION | STANDBY | |
AIWF031A | STANDBY | SERVICE | |
AIWF037A | THR for Normal | ||
AIWF037B | THR for Burst | ||
AIWF037C | THR calibration parameters | ||
AIWF038A | TDS common param | ||
AIWF038E | TDS for Normal | ||
AIWF038B | TDS for SBM1 | ||
AIWF038C | TDS for SBM2 | ||
AIWF038D | TDS LFM | ||
AIWF038F | TDS for Burst | ||
AIWF039A | LFR for SBM1 | ||
AIWF039B | LFR for SBM2 | ||
AIWF039C | LFR common param | ||
AIWF039D | LFR for Normal | ||
AIWF039E | LFR for Burst | ||
AIFW034A | Dump TDS,LFR,THR parameters | ||
AIWF035A | SERVICE | SCIENCE NORMAL | |
AIWF035B | SCIENCE NORMAL | SCIENCE BURST | |
AIWF045A | SCIENCE BURST | STANDBY | |
Patch | AIWF043A | STANDBY | SERVICE |
AIWF261A | Patch MEMORY | ||
AIWF260A | Dump memory | ||
Standart switch off procedure | AIWF046A | SERVICE | SAFE |
AIWF001A | SAFE | OFF |